• 206,000 square feet of covered heated plant buildings situated on 20 acres of land
• High Bay area serviced by three 75 Ton cranes
• Five Low Bay areas serviced by up to 40 Ton cranes
• Two X-ray bunkers
• One stress relieve furnace - 60' deep x 14' wide x 15' high - automatic controlled gas fired
• One shot blast room - 52' long x 22' wide x 17' high
• Large outdoor storage yard serviced by a Yard Gantry crane

• 3 - Iridium 192 sources (100, 50 & 25 curies)
• 1 - Cobalt 60 source (200 curies)
• 2 - Krautkramer USP11 Ultrasonic machines
• 1 - Sonatest computer interfaced Ultrasonic machine
• 2 - 1500 amp Magnaflux machines
• 6 - portable yoke mag machines

• Cladding station using oscillated submerged arc overlay (wire or strip) of tubesheets to 12 feet in diameter with carbon, stainless, Inconel, etc. consumables
• 2 - Two wire Tandem (AC/DC x 5/32" each) sub-arc welding station
• 3 - Single wire (5/32") sub-arc welding stations
• 1 - F.C.A.W. nozzle welder
• 6 - Programmable pulsed arc machines for tube to tubesheet welding
• 2 - Programmable pulsed arc machines for tube to tubesheet fillet welding
• 2 - Auto-feed stud welding machines
• 50 - S.M.A.W. power sources
• 20 - MIG power sources
• 13 - TIG power sources

• 1 - Set of plate rolls capable of:
  • Maximum width of 12' @ 2" thick. Rolled diameter of 32" to 144"
  • Maximum width of 5' @ 4" thick. Rolled diameter of 140"
• 1 - 400 Ton brake press
• 1 - 1/4" x 10' wide shear
• 1 - CM-56 electric eye shape cutting machine
• 1 - Plate edge prep machine
• 1 - Head burning machine - maximum circle 14'
• 1 - 500 Ton hydraulic press

• 1 - Peck panelizing machine (4 welding heads)
• 1 - Clam shell relieving furnace
• 1 - Multi-die horizontal panel press bender
• 1 - 3 1/2" tube bending machine
• 1 - 4" ENC tube bending machine
• 1 - Swaging machine
• 1 - 5" Dial-a-bend tube bending machine
• 1 - Gantry sub-arc welding machine (4 heads)
• 1 - Tube rotoblast machine (6 tubes at a time)
• 1 - Panel Trimmer

• 1 - Twin-headed Avey automated drum drill
• 1 - 144" vertical boring mill
• 1 - 56" vertical boring mill
• 1 - Planing mill - table 16' long x 47" wide
• 1 - Horizontal floor mill - spindle size 6 1/2" - travel 98" (vertical) x 124" (horizontal)
• 4 - Radial drills on tracks (25 HP) - 8' arm, 19" column - max drill size 4-3/16"
• 2 - Tape controlled 4 spindle gun drills (minimum 1/2" holes) max depth 42"
• 1 - Engine Lathe - 315" between centers with 40" swing
• Miscellaneous lathes, saws and milling machines

© Trenergy Inc.  
Site Designed and Maintained by Horizons Web Design